Flow Table (Hand Operated) IS: 5512-1983
Used for making flow tests for consistency of mortars in tests of hydraulic cements and pozzolanic materials.
It comprises the following

• A machined table top 250 mm dia of Gun metal fitted with a vertical shaft.
• A cast iron frame with a machined base and a smooth vertical hole at the top for the table shaft. It has a horizontal shaft carrying a cam at one end and a hand wheel at the other. The cam allows 12 mm free drop of the table.
• A conical mould 100 mm inside dia at bottom, 70 mm inside dia at top and 50 mm high.
•  Mild steel base plate 250 mm x 250 mm x 25 mm thick for fixing to the underside of the flow table
• Flow Mould

Flow Table (Motorised)

Same as above but that the cam shaft is driven by a motor drive at approximately 100 r.p.m.
Suitable for operation on 220/230 V, 50 Hz, single phase supply.

Flow Table (Hand Operated) IS: 1199-1959

Used for determination of fluidity of cement concrete mixture where the nominal size of aggregate does not exceed 38 mm.
It consist of the following

• A brass table top 762 mm dia, finely machined at the top and having reinforcing ribs at the bottom. A vertical shaft is fitted to the underside of the table in the centre.
• A cast iron frame with machined base and a polished smooth vertical hole at the for the table shaft. A horizontal shaft carries a cam at one end and a hand wheel at the other. The cam is adjusted to give a free drop of 12.5 mm to the table top.
• A conical mould in the form of frustum of a cone 250 mm inside dia at base, 170 mm inside dia at top and 120 mm high. It is provided with two lifting handles.

Flow Table (Motorised)

Same as above but with a motor drive for the cam shaft to drive it at approx 60 r.p.m.

Suitable for operation on 220 V, 50 Hz, single phase supply