Unique Scientific Instruments - Metal Testing, Concrete Testing, Cement Testing, Soil Testing, Rock Testing, Asphalt Testing, Aggregate Testing

OUR PRODUCTS

Torsion Testing Machine (Graph Type)

Torsion Testing Machine (Graph Type) Item Code: UMT-307

Torsion Testing Machine (Graph Type) for Rod 50 kgm.

Torsion Testing Machine is designed for conducting Torsion and twist tests on various metal wires, tubes, sheet materials. Torque measurement is by Pendulam Dynameter System. Torque ranges can be adjusted. Torque can be applied to specimen by geared motor through gearbox. Autographic recorder can be provided to know relation between torque and angle of twist on specific request.

The Accuracy of the torque indication +1% of the true torque.

SPECIFICATIONS

Capacity kgm	Ranges kgm	Clearance Between Grips (mm)	Grips for round bars mm (0)	Grips for flat bars mm	Width (mm)	Motor 3 ph hp
6	6 & 3	0-400	4-12	1-5	25	0.5
10	10,5&2	0-420	4-12	2-8	25	0.5
20	20,10	0-450	7-20	3-10	30	0.5
50	50,25	0-500	10-25	5-12	40	2.0
100	100,50	0-600	10-30	5-15	50	2.0
200	200,100	0-1000	20-35	10-20	60	3.0

Wire Torsion

Item Code: UMT-308

Torsion Testing Machine for Wire Elect- Operated

The number of twists required of fracture a wire sample can be determined rapidly with this machine. The standard machine consists of three speed gear box coupled with a motor to give output of 30,60 & 90 rpm. A revolution counter indicates the fails. The distance between the rotating and non-rotating chuck can be altered between 1-500mm length. The wire is held in between these two chucks. The wires from 1 to 10mm can be tested with this machine. The machine is electrically operated suitable for operation on 400/440 volts, 3 phase, A.C. supply.

Torsion Testing Machine 50 Kgm

Item Code: UMT-313

Torsion Testing Machine consists of two independent chucks where, the specimen can be placed one of which is rotated by electric motor and the speed is reduced through suitable reduction gear. The twist is communicated through the test piece to the other jaw o which a weighted pendulum attached. The resistance to deflection of pendulum caused a torque to be applied to the test piece and the angles of deflection of pendulum are the measure of Torque. A scale with pointer is fixed on the frame, which enables measurement of torque. The machine is built for maximum twisting movement at about 50 kgm. It is equipped with jaws for accommodating test pieces of 10 mm, 20mm size either square or circular with square shoulders. The machine can be operated by hand in case of powder failure suitable of 440 V. A..C. single phase.